Select Page

How to Turn a Shaker Leg on a Lathe

Anissa Kapsales, Cari Delahanty

Originally published Dec 16, 2009

Learn how to turn Shaker-style leg that’s perfect for a cherry side table. (Find out how to build a table that matches this leg in Christian Becksvoort’s article Shaker Classic, 2 Ways.)

Turning this leg could be a bit of a challenge for a novice, but the techniques are pretty basic.

There are a few points to keep in mind:

  • The transition where the square top turns round
  • The ¼ -in.-wide ring just under that, the maximum diameter
  • The gentle taper down to the bottom of the leg

Going from the square top portion to the round at a 90° angle is a little tricky, since a false move can knock off the corners.

First, measure and mark the transition location on all four sides of the leg. Then begin turning with a ½ -in. gouge as close to that point as possible.

Next, with a diamond-point scraper held on edge, carefully cut in at 90°.

Move the tool straight in to slice and clean up the shoulders, cutting in just deep enough to form a round. Now clean up the round ring to about 1-1/4 in. dia. Just under that, cut in another 1⁄8 in. to reduce the diameter.

Mark down 5 in. and cut a thin line at the maximum diameter (1¼ in.). Then use the diamond-point tool to cut to the bottom. To form the swell taper, I use a gouge and turn from below the transition ring to the max point, then taper gently to the bottom.

Finish with sand paper and 0000 steel wool. Add a light bevel at the bottom. On all the legs (tapered and turned), I break square corners with P220-grit sandpaper.

Get woodworking tips, expert advice and special offers in your inbox



Published at Tue, 17 Jan 2017 04:00:00 +0000


Pin It on Pinterest

Share This